Document Outline

• Important User Information
• Summary of Changes
• Table of Contents
• Preface
  • What SCADA Information Is Available?
  • Audience
  • Contents of this Manual
  • Terms
  • Address Conventions
  • Related Publications
• Designing Communication
  • Chapter Objectives
  • Choosing a Polling Mode for DF1 Half-Duplex Master
  • Communication Scheme Design Using Standard-Mode
  • Communication Scheme Design Using Message-Based Mode
  • Designing Communication for DF1 Full-Duplex Protocol
  • Designing Communication for DF1 Radio Modem Protocol
  • What to Do Next?
• Configuring Enhanced PLC-5 Processors
  • Chapter Objectives
  • Overview
  • Installing the Processor
  • Configuring a DF1 Half-Duplex Standard Mode Master Station
  • Configuring a DF1 Half-Duplex Message-based Mode Master Station
  • Configuring the Processor as a Slave Station
  • Configuring the Processor as a Station on a Point-to-Point Link
  • Messaging
• Configuring MicroLogix 1100/1200/1500 Controllers
  • Chapter Objectives
  • Overview
  • Installing the Controller
  • Using Modems that Support DF1 Communication Protocols
  • Modem Control Line Operation
  • Configuring DF1 Half-Duplex Channel 0 Parameters
  • Configuring a Standard-Mode DF1 Half-Duplex Master Station
  • Configuring a Message-based Mode DF1 Half-Duplex Master Station
  • Configuring a Slave Station
  • Configuring Poll Timeout
  • Configuring a Radio Modem Station
  • Configuring a Station on a Point-to-Point Link
  • DF1 Messaging
  • Example MSG Control Blocks
  • Modbus RTU Protocol
  • Data Logging
  • Conditions that Will Erase the Data Retrieval File
• Configuring SLC 5/03, 5/04, and 5/05 Processors
  • Chapter Objectives
  • Overview
  • Installing the Processor
  • Using Modems that Support DF1 Communication Protocols
  • Modem Control Line Operation
  • Configuring DF1 Half-Duplex Channel 0 Parameters
  • Configuring a Standard-Mode DF1 Half-Duplex Master Station
  • Configuring a Message-based Mode DF1 Half-Duplex Master Station
  • Configuring a Slave Station
  • Configuring Channel 0 Poll Timeout
  • Configuring a Radio Modem Station
  • Configuring a Station on a Point-to-Point Link
  • Messaging
  • Example MSG Control Blocks
• Configuring SLC 500 Processors with 1747-KE Interface Modules
  • Chapter Objectives
  • Overview
  • Installing the Processor
  • Installing the 1747-KE Interface Module
  • Configuring the Processor
  • Configuring the 1747-KE Interface Module
  • Messaging
• Configuring MicroLogix 1000 Controllers
  • Chapter Objectives
  • Overview
  • Installing the Controller
  • Automatic Protocol Switching
  • Using Modems that Support DF1 Communication Protocols
  • Modem Control Line Operation
  • Configuring a Slave Station
  • Configuring RTS Send Delay and RTS Off Delay
  • Configuring Poll Timeout
  • Configuring a Point-to-Point Station
  • Messaging
• Configuring Logix Controllers
  • Chapter Objectives
  • Overview
  • Installing the Controller
  • Using Modems that Support DF1 Communication Protocols
  • Configuring the Controller to Use the Serial Port
  • Modem Control Line Operation
  • Configuration Considerations for RTS Send and Off Delays
  • Configuring a Standard-Mode DF1 Half-Duplex Master Station
  • Configuring a Master Station for Standard Polling Mode
  • DF1 Half-Duplex Master Diagnostic Counter
  • Configuring a Message-Based Mode DF1 Half-Duplex Master Station
  • Configuring a Master Station for Message-based Polling Mode
  • Configuring the Controller as a Slave Station
  • Configuring Slave Poll Timeout
  • DF1 Half-Duplex Slave Diagnostic Counters
  • Configuring the Controller as a Station on a Point-to-Point Link
  • DF1 Point-to-Point Diagnostic Counters
  • Accessing DF1 Diagnostic Counters
  • Messaging
  • Example MSG Control Blocks
  • Logix Controller Error Codes for PLC and SLC Messages
• Configuring Modems
  • Chapter Objectives
  • Installing a Modem
  • Configuration Tips
  • Telephone Modem Configurations
  • Rockwell Automation
  • DATA-LINC Group
  • Miille Applied Research Company, Inc. (MARC)
  • Radio Modem Configurations
  • DATA-LINC Group
  • Electronic Systems Technology (ESTeem)
  • Microwave Data Systems (MDS)
  • Power Line Modem Configurations
  • DATA-LINC Group
• Configuring RSLinx Classic Software for DF1 Half-Duplex Communications
  • Chapter Objectives
  • Configuring RSLinx Classic Version 2.x as a Master Station
  • Configuring RSLinx Classic Version 2.x as a Slave Station
• Using Dial-up Telephone Communication
  • Chapter Objectives
  • Overview
  • Setting up the System
  • Communicating Over the Telephone Line
  • Peer-to-Peer Communication
  • Report-by-Exception and/or Master Station-Initiated Communication
• Remotely Program Allen-Bradley Processors Over a Telemetry Network
  • Chapter Objectives
  • Remote Programming via RSLinx® Gateway™
  • Remote Programming via SLC 5/05 Ethernet to DF1 Passthru
  • Remote Programming via Logix EtherNet/IP to DF1 Bridge
• Modem Cable Reference
  • Appendix Objective
  • Enhanced PLC-5
  • 1747-KE Interface Module
  • ASCII Terminal to 1747-KE module
  • SLC 5/03, 5/04, or 5/05, Logix, and MicroLogix 1500 Channel 1
  • 1785-KE Module
  • MicroLogix
• Basic DF1 Protocol Troubleshooting
  • Appendix Objectives
  • General Tips
  • Communication Troubleshooting
  • DF1 Half-Duplex Protocol
  • DF1 Full-Duplex Protocol
  • DF1 Radio Modem Protocol
• Third-Party Supplier Contact Information
  • Appendix Objectives
  • Contact List
• Worksheets
  • Appendix Objective
  • When You’re Finished
  • How to Use the Worksheets
  • Worksheet 1.1 SCADA System Schematic
  • Worksheet 2.1 Enhanced PLC-5 DF1 Half-Duplex Master Station Configuration Using Standard Communication
  • Worksheet 2.2 Enhanced PLC-5 DF1 Half-Duplex Master Station Configuration Using Message-based Communication
  • Worksheet 2.3 Enhanced PLC-5 DF1 Half-Duplex Slave Station Configuration
  • Worksheet 2.4 Enhanced PLC-5 DF1 Full-Duplex Point-to-Point Configuration
  • Worksheet 3.1 MicroLogix 1100/1200/1500 DF1 Half-Duplex Master Station Configuration Using Standard Communication
  • Worksheet 3.2 MicroLogix 1100/1200/1500 DF1 Half-Duplex Master Station Configuration Using Message-based Communication
  • Worksheet 3.3 MicroLogix 1100/1200/1500 DF1 Half-Duplex Slave Station Configuration
  • Worksheet 3.4 MicroLogix 1100/1200/1500 DF1 Full-Duplex Point-to-Point Configuration
  • Worksheet 3.5 MicroLogix 1100/1200/1500 Radio Modem Slave Station Configuration
  • Worksheet 4.1 SLC 5/03, 5/04, and 5/05 DF1 Half-Duplex Master Station Configuration Using Standard Communication
  • Worksheet 4.2 SLC 5/03, 5/04, and 5/05 DF1 Half-Duplex Master Station Configuration Using Message-based Communication
  • Worksheet 4.3 SLC 5/03, 5/04, and 5/05 DF1 Half-Duplex Slave Station Configuration
  • Worksheet 4.4 SLC 5/03, 5/04, and 5/05 DF1 Full-Duplex Point-to-Point Configuration
  • Worksheet 4.5 SLC 5/03, 5/04, and 5/05 DF1 Radio Modem Station Configuration
  • Worksheet 5.1 SLC 500 Processor with 1747-KE Module DF1 Half-Duplex Slave Station Configuration
  • Worksheet 5.2 SLC 500 Processor with 1747-KE Module Point-to-Point Configuration
  • Worksheet 6.1 MicroLogix 1000 DF1 Half-Duplex Slave Station Configuration
  • Worksheet 7.1 Logix DF1 Half-Duplex Master Station Configuration Using Standard Communication
  • Worksheet 7.2 Logix DF1 Half-Duplex Master Station Configuration Using Message-based Communication
  • Worksheet 7.3 Logix DF1 Half-Duplex Slave Station Configuration
  • Worksheet 7.4 Logix DF1 Full-Duplex Point-to-Point Configuration
• Sample Ladder Logic
  • Appendix Objective
  • SLC DF1 Half-Duplex Master Standard Mode, Master-initiated MSG
  • SLC DF1 Half-Duplex Master Message-based Mode and DF1 Radio Modem initiated MSG
  • SLC DF1 Half-Duplex Slave and DF1 Radio Modem Report-by-Exception MSG
  • PLC-5 and MicroLogix 1100/1200/1500 DF1 Half-Duplex Master Standard Mode, Master-initiated MSG
  • PLC-5 and MicroLogix 1100/1200/1500 DF1 Half-Duplex Master Message-based, Master-initiated MSG
  • PLC-5 and MicroLogix 1100/1200/1500 DF1 Half-Duplex Slave Report-by-Exception MSG
  • MicroLogix 1000 Analog DF1 Half-Duplex Slave Report-by-Exception MSG
  • Logix DF1 Half-Duplex Master Standard Mode, Master-Initiated MSG
  • Logix DF1 Half-Duplex Master Message-based Mode, Master-Initiated MSG
  • Logix DF1 Half-Duplex Slave Report-By-Exception MSG
• Glossary
• Index
  • Numerics
  • A
  • B
  • C
  • D
  • E
  • F
  • G
  • H
  • I
  • J
  • L
  • M
  • N
  • O
  • P
  • R
  • S
  • T
  • V
  • W