Rockwell Automation 6157-C User Manual - Manual (Page 14)

14 Industrial 19" CRT Monitor
Publication 6157-UM001A-EN-P
When properly installed, the 6157-CB industrial monitor is designed to
provide protection to NEMA 1 (IP 10 equivalent) standards.
The rack mounting versions of the 6157- C Industrial Monitor are
designed for installation in a rack enclosure that conforms to EIA
standards for equipment with 19" (483 mm) wide rails.
Note: Retainer screws prevent the unit from being pulled out on
its slides accidentally; they are not intended to support the
weight of the unit.
Tools Needed
You will need the following tools and hardware:
•
EIA panel mounting hardware
•
Chassis slides or shelf
•
Screwdriver
Rack Mounting Guidelines
Observe the following precautions when installing this unit in a rack:
•
The cabinet must be tall enough to accommodate the monitor's panel
height of 9 rack units, 15.75 in. (400 mm), and deep enough to
accommodate the monitor's depth while providing rear clearance for
cabling and air flow. A cabinet with depth of 24 in. (610 mm) is
sufficient. A minimum clearance of 4 in. (102 mm) from the top
inside edge of the rack is required for airflow.
•
The monitor is designed to be supported in the cabinet by telescoping
slides. Slide mounting points are provided on the lower sides of the
monitor chassis. These mounting points are designed to accommodate
General Devices Co. Chassis-Trak
® Model C-300-S or equivalent
slides. Slides of this kind are available from Rockwell Automation in
18 in. and 24 in. lengths, with or without 6 in. extenders.
Rack Mounting (6157-CB)