Rockwell Automation 6157-C User Manual - Manual (Page 47)

Industrial 19" CRT Monitor 47
Publication 6157-UM001A-EN-P
The BNC cables you use with this monitor uses a conventional HD-15
connector at the monitor end to connect the 6157- C Industrial Monitor
to the host computer with five BNC connectors:
•
R, B, and G: Red, Green, and Blue input connectors to establish
color. These are used for RS-343 analog signals.
•
HS/CS: Separate horizontal/composite sync signal from the video
source.
•
VS: Separate vertical sync signal from the video source.
Figure 14
BNC Video Connector
The following table describes the signal types you can use with these
BNC connectors:
Table H
BNC Signal Types
BNC Signal Type Description R G B HS/
CS
VS
Sync-on-Green Use the three video connectors. Horizontal
and vertical syncs are supplied on the green
video line. X X X
Separate
Composite Sync Use the three video connectors plus the
horizontal sync/composite sync input. X X X X
Separate
Horizontal and
Vertical Sync Use the three video connectors plus the
horizontal sync/composite sync and vertical
sync input. X X X X X
BNC Connectors