Rockwell Automation 6157-C User Manual - Manual (Page 17)

Industrial 19" CRT Monitor 17
Publication 6157-UM001A-EN-P
Rack Mounting Procedure
Step 1 - Locate the mounting areas:
You must allocate the required space in your enclosure for the monitor.
The monitor’s panel height is 9 rack units (15.75 in. or 400 mm) and you
must determine if panel spacers are required above or below the monitor.
Locate the following areas to mount the slides:
•
Locate the points at which the bottom edge of the monitor front panel
will intersect the cabinet front mounting rails. The four slots in the
monitor front panel should be aligned with holes in the front
mounting rails.
•
Locate points on the front rails 5.25 in. (133 mm) above the points of
where the bottom edge of the monitor panel intersects the rail. These
points indicate the center line of each slide.
•
Locate points on the rear rails equal in height to the slide center line
points on the front rails.
Figure 7
Mounting Areas on a Rack