Rockwell Automation 6157-C User Manual User Manual
Page 19
Industrial 19" CRT Monitor
19
Publication 6157-UM001A-EN-P
4.
Repeat these steps to mount the stationary section of the other slide
to the front and rear mounting rails on the opposite side.
5.
Measure the space between the inside edges of the stationary slides
to determine the clearance. Adjust the spacing to 16.8 in. (427 mm
6.
Fully tighten the mounting screws holding the stationary sections to
the front and rear mounting rails of the cabinet.
7.
Locate the holes in the front mounting rails corresponding to the
monitor’s front panel mounting holes. Install clip nuts behind the
holes in the rails if the holes are not threaded.
Step 3 - Mount the slides on the monitor:
1.
Take up the sections of the slides previously removed from the
stationary sections. Pull the interior sections out of the intermediate
sections far enough to gain access to the mounting holes in the
interior sections.
2.
Align the interior section’s mounting holes with corresponding holes
on the brace of the monitor chassis. Attach the interior section of the
slide to the side of the chassis with hardware supplied. Tighten
screws securely.
3.
Repeat these steps to attach the interior section of the other slide to
the opposite side of the chassis.
Step 4 - Install the monitor in the cabinet:
1.
Position the monitor chassis, with slide extensions installed, in front
of the prepared cabinet.
2.
Lift the monitor chassis to the height required to align the
intermediate sections of the slides (attached to the chassis) with the
corresponding stationary sections (attached to the cabinet rails).
ATTENTION: To avoid danger of personal injury or
accidental damage to equipment, it is recommended
the monitor be lifted by two persons, both wearing
back braces.
3.
Push the intermediate sections of the slides into the stationary
sections until the retaining locks are engaged.
4.
If the monitor will be accessible from the rear after installation,
cabling may be installed from the rear at a later time. Otherwise,
power and video cabling should be installed at this time, while the
monitor is supported by the slides in extended position.