Rockwell Automation 47C626 AutoMax Programming Executive V4.2 - Manual (Page 206)

18Ć20
The columns in the force table contain the following information:
(#) Ć Force table (page) position (1Ć16).
Task Ć The task in which the variable is defined. This field
is blank if the variable is COMMON.
Variable Ć Name of the variable being forced, including the
type character.
Value Ć The current forced value of the variable.
See figure 18.7 for a the Monitor Force menu.
ON LINE Direct via Serial C: \AMXLIB\SYS\RACK
Monitor Force
#Task Variable Value
EscăExit
F1 Help
Unforce PgUp/PgDown Switch Page Force
P1:0 P2:0 P3:0 P4:0
Figure 18.7 Ć Monitor Force Menu
18.5.2 Forcing a Variable
To force a variable, follow the directions below.
1. At the Monitor menu, enter F" for Force. See Figure 18.8 for a
sample screen containing 14 forced variables. Note that no task
is shown for common variables.