Rockwell Automation 47C626 AutoMax Programming Executive V4.2 - Manual (Page 85)

5Ć51
D Section 10.0 Ć AutoMax Processor Overview Ć Describes the
AutoMax Processor module and online operation of the AutoMax
distributed control system.
D Section 11.0 AutoMax Online Menu Ć Describes how to load, run,
stop, monitor, and modify application tasks in the rack. Also
describes Processor error logs.
D Section 12.0 Ć Online Menu: Connect Ć Describes how to change
the baud rate, enter/release the password, and enable and
disable AUTO RUN of application tasks.
D Section 13.0 Ć Online Menu: Info/Log Ć Describes how to display
information about the system software on any Processor or UDC
module in the rack and how to view the status and error log for
tasks.
D Section 14.0 Ć Online Menu: Transfer Ć Describes procedures for
changing the default path or viewing the contents of the default
system. Also contains procedures for loading tasks onto the rack
and saving application tasks from the rack.
D Section 15.0 Ć Online Menu: Running Tasks Ć Describes how to run
tasks.
D Section 16.0 Ć Online Menu: Stopping Tasks Ć Describes how to
stop tasks.
D Section 17.0 Ć Online Menu: Deleting Tasks Ć Describes how to
delete tasks from the rack.
D Section 18.0 Ć Online Menu: Monitoring and Editing Tasks Ć
Describes how to monitor and change status of variables and I/O
points, display and modify Ladder Logic sequences in real time,
and force and unĆforce variables.
D Section 19.0 Ć Online Menu: Error Clear Ć Describes how to clear
the Processor or UDC error log or errors displayed on the
Processor LEDs.
D Section 20.0 Ć Software Troubleshooting Ć Describes typical errors
that can occur and procedures for correcting these errors.
5.6.2 Monitoring a PC Program Online
Select Monitor PC Program from the Online menu to call the AutoMax
Ladder Editor. Refer to J2Ć3093 for instructions on using the AutoMax
Ladder Editor to monitor a PC task online.