Rockwell Automation MPAR Electric Cylinders - Manual (Page 24)

24 MP-Series Electric Cylinders
Rockwell Automation Publication MPAR-IN001D-EN-P - September 2012
2. Click the Homing tab.
3. Set parameters for either absolute homing or torque level-to-marker homing as shown on
this table.
4. Complete these steps for absolute homing.
a. Use motion direct commands to slowly jog your axis to your application's home
location, being sure to not exceed 10 mm/s (0.4 in/s).
b. Issue the Motion Direct Command (MAH) to set the home position on your axis.
5. Click the Limits tab.
6. Enter these parameters.
Parameter Absolute Homing Value Torque Level-to-marker Homing Value
Mode Absolute Active
Position 0, typical 0, typical
Offset N/A 0 mm
Sequence Immediate Torque level-to-marker
Direction N/A Reverse bidirectional
Torque Level N/A 30%, min
Greater if the system friction, force, or weight exceeds 30% of
the Continuous Force Rating at any point in the range of
motion
Speed N/A 10 mm/s (1.97 in/s)
Return Speed N/A 10 mm/s (0.39 in/s)
ATTENTION: Avoid excessive force while homing the electric cylinder. Do not exceed
10 mm/s (0.4 in/s) during a home routine.
Speeds greater than 10 mm/s (0.4 in/s) may damage the electric cylinder when the
piston rod reaches the end of travel.
Parameter Entry/Selection (with applicable distance unit settings)
Hard Travel Limits Check if hardware limits are in use. Use the Motion Analyzer software to determine the
maximum stopping distance in your application to set negative and positive limits.
Soft Travel Limits Check if software limits are in use. Use the Motion Analyzer software to determine the
maximum stopping distance in your application to set negative and positive limits.
Maximum Positive Enter value that is within the piston-rod mechanical travel.
Maximum Negative Enter value that is within the piston-rod mechanical travel.