Rockwell Automation T8082 Trusted Toolset Suite - Manual (Page 25)

Trusted
TM
Toolset Suite T8082
Issue 14 Feb 10 PD-T8082 25
2.3.7. Module LED State Editor
From the Template Creation window, select LED Template and select Module in the LED Config
section. Select the Edit button. This will cause the Module LED Editor window to be displayed, as
shown in Figure 11 below.
Figure 11 Module LED State Editor
To change the colour and operating mode of the LED, point and click the left-hand mouse button on
the required State LED icon. These changes will apply to all channel LEDs on the I/O modules that
this template is applied to. The LED appearance for each state is then animated on the editor window.
When the correct LED states have been entered, the user must select the OK button. This will return
the user to the Template Creation window which permits the newly created template to be saved. The
filename must not include any spaces. Underscores are recommended.
Note that state 7 is a module fault. States 8 to 15 are not used for modules except the 8449 Valve
Monitor Module. For this module, valve outputs and position inputs are grouped in pairs. States 0 to 7
are the output states 0 to 7 described in section 2 above. States 8 to 15 are the position input states 0
to 7 described in section 1 above.