Rockwell Automation T8082 Trusted Toolset Suite - Manual (Page 30)

Trusted
TM
Toolset Suite T8082
Issue 14 Feb 10 PD-T8082 30
2.3.11. Module System Information Template Editor
From the Template Creation window, select Module System Information, then select the Edit
button. This will cause the Module window shown in Figure 14 below to be displayed.
Figure 14 Module System Information Template Editor
The window above shows arbitrary values in the IMB Timeout and Watchdog Timeout windows.
These may be changed and added by selecting Add as required.
It is recommended to set the above timeouts so that the module is polled at least four times at the
normal scan time within the timeout, taking scheduled polling into account. For example, if the ‘current’
scan time is 200 milliseconds (as reported in the Toolset Debugger window), and the module is set for
scheduled polling every 5
th scan, then both timeouts (they operate in a similar way) need to be set to
200 x 5 x 4 = 4000ms minimum. Ensure that the timeouts are still safe, i.e. less than half the process
safety time.
The Miscellaneous window will normally be blank when initially editing this template. Timeout values
for Power Fail and Bypass must be entered using this window, in the syntax shown in section 2.3.10.
When the correct timeout values have been entered, the user must select the OK button. This will
return the user to the Template Creation window which permits the newly created template to be
saved. The filename must not include any spaces. Underscores are recommended.
The Pulse Train Module is discontinued and its associated tab should not be used.
2.3.12. Module Flags Templates (Future Use Only)
Input Modules
There are two possible entries for this template; Currentsink and Ratiometric. The syntax and function
of each entry is described below. These settings apply to the entire module.
Currentsink = < TRUE | FALSE (default) >