Rockwell Automation T8082 Trusted Toolset Suite - Manual (Page 26)

Trusted
TM
Toolset Suite T8082
Issue 14 Feb 10 PD-T8082 26
2.3.8. Channel LED State Editor
From the Template Creation window, select LED Template and select Channel in the LED Config
section. Select the Edit button. This will cause the Channel LED Editor window to be displayed, as
shown in Figure 12 below.
Figure 12 Channel LED State Editor
Each channel can be individually configured with an LED state/colour map. To change the colour and
operating mode of a channel LED, first select the channel to edit. Several channels may be selected at
once using Ctrl-click or Shift-click. To change the LED appearance in a particular state, point and click
the left-hand mouse button on the required State LED icon. The LED appearance for each state is
then animated on the editor window. These changes will apply to the selected channel LEDs on the I/O
modules that this template is applied to.
The channels may also be assigned to the default LED state/colour map. Channels with a D
symbol as shown left use the default map. To define whether a channel uses the default map or
a specific map, select ‘Use Default’ or ‘Use Editor’ in the ‘Channel Options’ section. To edit the default
map, select ‘Default’ at the top of the channel list and edit the LED colours.
A channel LED map may be assigned as the default by selecting the channel and selecting ‘Default <-
Current’ in the ‘Default LED State’ section. A channel specific map may be changed to the current
default by selecting the channel and selecting ‘Current <- Default’ in the ‘Default LED State’ section.
The channel still has a specific LED map but it now matches the default.