Rockwell Automation 1440-RMA00-04RC XM-440 Master Relay Module - Manual (Page 41)

41 Rockwell Automation Publication GMSI10-UM009D-EN-P - June 2011
Chapter
3
Configuration Parameters
This chapter provides a complete listing and description of the XM-440
parameters. The parameters can be viewed and edited using the XM Serial
Configuration Utility software and a personal computer. If the module is
installed on a DeviceNet network, configuring can also be performed using a
network configuration tool such as RSNetWorx (Version 3.0 or later). Refer to
your configuration tool documentation for instructions on configuring a
device.
XM Network Node List The XM Network Node List parameters identify the XM measurement
modules on the network. Use these parameters to set up the XM-440 Node
List (or Scanlist in the EDS file).
For information about See page
XM Network Node List 41
Relay Parameters 45
Group Triggers Parameters 48
Device Mode Parameters 50
Event Log Parameters 50
IMPORTANT
The
The appearance and procedure to configure the parameters
may differ in different software.
TIP
Refer to Using RSNetWorx with the XM-440 on page 62
for more information on setting up the XM-440 Scanlist.
XM Network Node List Parameters
Parameter Name Description Values/Comments
Node Address (XM Configuration
Utility only) The XM measurement module’s node address.