Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 52)

2–12

RSView32 User’s Guide
Commands for switching drivers
Use the following commands to switch drivers:
DriverPrimary <channel>
Switches from the secondary driver to the primary driver on the
specified channel.
<channel> The number of the channel (1 through 4) that is
being switched from its secondary to primary driver.
DriverSecondary <channel>
Switches from the primary driver to the secondary driver on the
specified channel.
<channel> The number of the channel (1 through 4) that is
being switched from its primary to secondary driver.
DriverToggle <channel>
Switches from the current driver to the one not being used on the
specified channel.
<channel> The number of the channel (1 through 4) that is
being switched from one driver to another.
Switching drivers automatically
To switch drivers automatically, create an event in the Events editor. In
the Action field of the Events editor, type a driver command as the
action that will be triggered when an expression results to true. In the
Expression field, create an expression that will trigger the action.