Rockwell Automation 9301 Series RSView32 Users Guide - Manual (Page 635)

RSView32 commands

A–15
<EventType> The type of alarm transaction, which must be one of
the following:
[IntoAlarm] Indicates that the tag has gone into
or [In]
alarm.
[OutOfAlarm]Indicates that the tag has gone out
or [Out]
of alarm.
[InAndOut Indicates that an alarm has occurred,
OfAlarm] but the tag is again immediately out of
or alarm, such as a digital change–of–
[InAndOut] state alarm.
[TagType] The type of tag which must be one of:
[/A] Analog
[/D] Digital
If you don’t specify either /A or /D, the alarm is
assumed to be analog.
[/VTagValue] A floating–point value associated with the alarm
event. If the floating–point value is not specified, the
tag value is 0.0.
If the name of an alarm event is the name of a tag in
the tag database, the value specified by this parameter
will not update the tag’s value in the value table.
[/SSeverity] The alarm severity. The severity is an integer from 1
to 8. Alarm severity can be specified only for alarm
events of type IntoAlarm, or InAndOutOfAlarm. If
a value is not specified, the alarm severity is 1.
[/HTime– The time stamp associated with the alarm
stamp] transaction, in the format:<HH:MM:SS>[Date]: