Profile toolbar – Rockwell Automation Motion Analyzer Software User Manual
Page 145
Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
145
Sizing Your System
Chapter 2
2.2.2.1. Profile Toolbar
The Profile toolbar contains buttons and pull-down menus for adding, moving,
and removing profile segments or an entire motion profile.
Figure 103 - Profile Toolbar Features
Table 80 - Profile Toolbar Features (label 1 in
)
Feature
Description
Segment Selector
Use the Segment Selector arrows (red box in
) to navigate through the various
segments in your motion profile. As you navigate to a profile segment, the associated
and
are displayed. The Zero profile
segment is the start condition.
Profile
Lets you copy a motion profile from another axis in your Motion Analyzer project. It also lets
you go to the
More Options Profile Editor Mode
for another axis in your Motion Analyzer
project.
Start Condition
Opens the Segment Parameters window and the Segment Plot window for the start
condition.
Add
Lets you add profile segments to the end of your motion profile. Also, refer to the Segment
Parameters section for information about the various profile segments that are available in
the
More Options Profile Editor Mode
.