Rockwell Automation Motion Analyzer Software - Manual (Page 68)

68 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 1 Welcome to Motion Analyzer Software
Table 43 - Axis Mapping Symbols
If problems occur with selected catalog numbers, a warning icon and a note at the
bottom of the dialog box appears.
Figure 56 - Axis with Warning Icon
If export isn’t possible, a note at the bottom of the dialog box indicates what the
problem is. This axis is not exported to RSLogix 5000 software.
Figure 57 - Axis with Not Recommended Icon
If the number of axes a sercos module can support is exceeded, a new sercos
module is added into the pull-down menu in the third column. This is selectable
for the rest of the axes. This new module is also exported to the .L5X file.
4. Click Next.
Attribute Description
Axes will export without errors.
Axes with warning icon only partially export to RSLogix 5000 software. A note at the
bottom of the screen indicates what is wrong.
Not recommended icon. A note at the bottom of the screen indicates what is wrong.