Rockwell Automation Motion Analyzer Software - Manual (Page 219)

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 219
Understanding Your System Solution Chapter 3
3.2.2.1. Ratio/Design Analysis
You can use the Ratio/Design Analysis tool to analyze the effect of the
transmission or gear component ratios on the system performance and quickly
optimize the ratio values. This tool is not applicable for linear actuators.
When you click Ratio/Design Analysis, the following dialog box opens.
Depending on your system configuration, the following Ratio Analysis options
may be available to you:
• Gearbox
• Transmission 1
• Transmission 2
• Lead
• Sprocket PCD (sprocket pitch circle diameter)
• Pinion PCD (pinion pitch circle diameter)
• Drive Diameter
For more information, refer to Ratio Analysis on page 220 .
The Cut Length Analysis option is available when you use the Press Roll Feed
(constant time/constant angle) , Carriage Cut Off , or Cutter Knife Drive
application templates.
For more information, refer to Cut Length Analysis on page 221 .