Rockwell Automation Motion Analyzer Software - Manual (Page 223)

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 223
Understanding Your System Solution Chapter 3
3.2.2.2.1. Profile Tab
Follow these steps to adjust the profile parameters.
1. From the Segment No. pull-down menu,
choose the profile segment number you
would like to analyze.
2. Select the motion profile parameter.
This becomes the parameter corresponding
to the X-axis on the graph. The value next to
each parameter indicates the parameter value
based on the current system configuration.
3. Adjust the selected profile parameter range
and number of steps in the Low, High, and
Steps text boxes, as needed.
4. Click Plot Graph to refresh the chart when
you have finished entering the values.
5. Click Setup to designate a parameter to vary by checking the adjacent box
and/or clicking the radio button.
Designate an upper and lower limit for the parameter and the number of
steps to observe on the graph within the specified range.
6. Click Plot to see the graph of the selected parameter versus time.
7. Click OK.