Rockwell Automation Motion Analyzer Software - Manual (Page 238)

238 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 3 Understanding Your System Solution
5. Click Refresh when changes are made to the associated SolidWorks model
to make sure Motion Analyzer software is interfacing with the most recent
version of the SolidWorks assembly.
6. After verifying that this is the correct model, select the desired motion
study and force element.
Table 138 - SolidWorks Load Definitions
7. Click OK to confirm the desired selections and go back to Dynamic
Simulation.
8. Click Run Simulation to invoke SolidWorks based simulation.
9. Click Stop Simulation to stop the analysis.
Options Description
Selected SolidWorks
Assembly
Displays the location of the selected SolidWorks model.
Selected SolidWorks
Study From the pull-down menu, select the desired SolidWorks motion study from the
existing motion studies in the currently selected assembly.
SolidWorks Force
Element
From the pull-down menu, select the SolidWorks force element.