Banner A-GAGE High-Resolution MINI-ARRAY Series - Manual (Page 10)

P/N 64118 rev. B
Specifications
10
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Status Indicators
Power Requirements 16 to 30V dc @ 1.0 A (typical: 0.5 A @ 16V dc)
Output 1 (red): Lights to indicate Discrete Output #1 is active
Alarm (red): Lights to indicate Discrete Output #2 is active
Gate (red): Lights to indicate GATE input is active
Align (green): Lights to indicate emitter and receiver are aligned
Diagnostics indicator: (Key on controller side label) Identifies System errors and status
Inputs Sensor input: Emitter and receiver wire in parallel to five terminals.
Gate input: Optically isolated, requires 10 to 30V dc (7.5kΩ impedance) for gate signal
Remote alignment input: Optically isolated, requires 10 to 30V dc (7.5kΩ impedance) for alignment
sequence signal
Discrete (Switched) Outputs NPN outputs: Open collector NPN transistor rated at 30V dc max., 150 mA max.
PNP outputs: Open collector PNP transistor rated at 30V dc max., 150 mA max.
All discrete outputs:
OFF-state leakage current: < 10 µA @ 30V dc
ON-state saturation voltage: < 1V @ 10 mA and < 1.5V @ 150 mA
Serial Data Outputs RS-232 or RS-485 interface. (Up to 15 control modules may be given unique addresses on one RS-485
party line.)
ASCII or binary data format
9600, 19.2K, or 38.4K baud rate
8 data bits, 1 stop bit, and even, odd, or no parity
Analog Outputs Voltage-sourcing outputs: 0 to 10V dc (25 mA current limit)
Current-sinking outputs: 4 to 20 mA (16 to 30V dc input)
Resolution: Span / Number of sensing channels
Linearity: 0.1% of full scale
Temperature variation: 0.01% of full scale per °C
System Programming Via RS-232 interface to PC-compatible computer running Windows® XP, Vista, or 7 and using
software supplied with each control module.
Construction Polycarbonate housing; mounts to flat surface or directly onto 35-mm DIN rail
Environmental Rating Control Module: NEMA 1, IEC IP20
Emitter/Receiver: NEMA 4, 13; IEC IP65
Output Configuration MAHCVP-1: Two PNP discrete (switched), two 0-10V voltage sourcing
MAHCVN-1: Two NPN discrete (switched), two 0-10V voltage sourcing
MAHCIP-1: Two PNP discrete (switched), two 4-20 mA current sinking
MAHCIN-1: Two NPN discrete (switched), two 4-20 mA current sinking
2.2 Control Module Specifications
Operating Conditions Temperature: 0° to +50°C (+32° to 122°F)
Maximum relative humidity: 95% @ 50°C (non-condensing)
Certifications