Banner A-GAGE High-Resolution MINI-ARRAY Series - Manual (Page 12)

P/N 64118 rev. B
Installation and Mechanical Alignment
12
Banner Engineering Corp. • Minneapolis, U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
3. Installation and Mechanical Alignment
3.1 Emitter and Receiver Mounting
Banner MINI-ARRAY emitters and receivers are small, lightweight, and easy to handle
during mounting. The mounting brackets (supplied) allow ±30° rotation.
From a common point of reference, make measurements to locate the emitter and
receiver in the same plane with their midpoints directly opposite each other. Mount the
emitter and receiver brackets using the vibration isolators and M4 Keps nuts (all
supplied). See Figure 3-1. Standard M4 or #8-32 bolts may be substituted (and the
vibration isolators eliminated) in situations where the emitter and receiver are not
subjected to shock or vibration forces. While the internal circuits of the emitter and
receiver are able to withstand heavy impulse forces, the vibration isolators dampen
impulse forces and prevent possible damage due to resonant vibration of the emitter or
receiver assembly.
Figure 3-1. A-GAGE High-Resolution MINI-ARRAY emitter and receiver mounting hardware
Mounting
Surface
M4 Keps
Nut (8)
M4 x 10 mm
Slotted Hex Head
with Com pres sion
Washer (2)
Mounting
Bracket
Emitter or
receiver
Anti-Vibration
Mount (4)
Mounting
Bracket
Washer
Nut
Studs: M4 x 0.7
9.5 mm (0.38") long