Banner MAXI-AMP Series - Manual (Page 23)

Model RS-11 Socket
Track model DIN-35-70 accomodates one RS-11 socket. Model DIN-35-105
holds two sockets. Model DIN-35-140 holds up to three sockets. The RS-11
socket is designed to snap (or slide) directly into the 35mm DIN track.
35mm DIN Rail Track Model BENC-4 Enclosure
The RS-11 is supplied with a coding ring and pin (see diagram at right). This allows a MAXI-AMP to be
keyed to fit only its own 11-pin socket. The pin is installed in one of the eleven slots in the RS-11, and the
notch in the ring is aligned to slip over the pin. When the MAXI-AMP is removed from the RS-11, the
coding ring stays with the MAXI-AMP base, while the coding pin remains in the socket.
Model RS-11 is an eleven-pole round-pin screw
terminal relay socket which is used to make elec-
trical connections to any MAXI-AMP module.
The socket provides in-line wire clamp screw
terminals which will accept from one #24 AWG
up to two #14 wires at each pin. The RS-11 is UL
recognized (file #E92191) and CSA approved (file
#LR38486). It may be mounted directly to a panel
plate or via standard 35mm DIN-rail track (see
below). A hold-down wire is supplied with each
RS-11 socket (see Dimension Diagram on page
22).
Model BENC-4 is a NEMA-4 rated corrosion-resistant enclosure for a MAXI-
AMP module or other control device. It is supplied with a DIN-35-70 track for
easy mounting of one RS-11 socket. For mounting two sockets, use DIN-35-105.
MAXI-AMP System
Mounting and Accessories
23
Accessories for MAXI-AMP Modules
After the panel cutout has been completed and de-
burred, slide the MAXI-AMP through the cutout and
place one clip assembly into the rectangular depression
on each of the two narrow sides of the housing. Orient
clips as shown, and alternately tighten the screws for
equal pressure against the inside of the panel wall. Do
not overtighten the screws. Attach the optional EC11-
6 extension cable (described below) to the MAXI-AMP
and route the opposite end of the cable to the RS-11 (or
equivalent) socket.
Model EC11-6 extension cable is 6 feet (2m) long.
Clips for panel wall mounting of the MAXI-AMP are
included with the cable.
Panel Wall Mounting of MAXI-AMP Module