Advanced setup, Vanced setup – Banner D10 Expert with Numeric Display—Discrete User Manual
Page 13
Push Button
Remote
0.04 seconds < T < 0.8 seconds
Result
Select
Speed and
Power Com-
bination
Click Dynamic (+) to toggle be-
tween selections.
Double pulse the remote
line to toggle between se-
lections.
T
T
T
Indicator Arrow Icons 1 and 2 ON Red
Super-high-speed
(50-μs response)
"SHS" (Comple-
mentary outputs;
see note below)
High-speed (200-
μs response)
"HS"
High-power (1-ms
response)
"HP"
Super-high-power
(2.5-ms response)
"SHP"
Return to
RUN mode.
OR
Click Static (-) to
save selection and
return to RUN
mode.
Single-pulse the remote
line to save selection and
return to RUN mode.
T
Proceed to
Advanced
Setup.
Quad-click Static
(-) to proceed to
Advanced Setup.
Quad-pulse the remote
line to proceed to Ad-
vanced Setup.
T
T
T
T
T
T
T
Super-High-Speed Operation Note: Under most conditions, the sensor’s two discrete outputs operate inde-
pendently. However, the outputs become complementary when operating at Super-High-Speed, due to its
extremely fast response time. Only channel 1 is taught/adjusted; channel 2 is complementary to it (output 1
conducts for the taught ON condition, and output 2 conducts for the OFF state). To invert these conditions
(output 1 – OFF condition, output 2 – ON), change light/dark operate setting.
Advanced Setup
• Advanced adjustments to previously configured sensor display and operating parameters
• Quad-click Static (-) or quad-pulse remote line before exiting “Power and Speed” settings to enter this mode
• Click Dynamic (+) or double-pulse remote line to select an option
• Click Static or single-pulse remote line to advance
• Changes are updated instantly
Push Button
Remote
0.04 seconds < T < 0.8 seconds
Result
Enter SET-
UP Mode
From "Power and Speed"
mode, quad-click the
Static (-) button.
From "Power and Speed"
mode, quad-pulse the remote
line.
T
T
T
T
T
T
T
• Indicator Arrow Icons 1
and 2 remain red
• Display shows "Track-
ing Enabled" option
D10 Expert™ - Analog and Discrete Outputs
P/N 65448_web
rev. F
www.bannerengineering.com - tel: 763-544-3164
13