Tweco 6000 CE Merlin - Manual (Page 16)

INTRODUCTION & DESCRIPTION 2-2 Manual 0-2601
2.03 Specifications & Design
Features
The following apply to the Master Power Supply only:
1. Controls
ON/OFF Switch, Output Current Control, RUN/SET/PURGE
Switch, Secondary Gas Regulator, Plasma Gas Regulator,
Secondary Mode Switch, Secondary Water Flowmeter/
Regulator, Optional Arc Hour/Counter Meters
2. Control Indicators
LED Indicators:
AC , TEMP, GAS, DC, PILOT, COOLANT PRES, and COOL-
ANT COND
Gauges:
Secondary, Plasma, and Coolant Pressure Gauges
3. Input Power
V o lt a g e F re q u e n cy P h a se A m p e ra g e
3 8 0 5 0 o r 6 0 H z 3 5 1
4 1 5 5 0 o r 6 0 H z 3 4 7
NOTE
Refer to Appendix 1 for recommended input wir-
ing size, current ratings, and circuit protection re-
quirements.
Amperage depends on input voltage (Refer to Ap-
pendix 1).
4. Output Power
Master Power Supply:
Continuously adjustable by potentiometer from 50
to 150 amps
With Slave Power Supply:
Continuously adjustable by potentiometer from
100 to 300 amps
5. Duty Cycle (see NOTE)
NOTE
The duty cycle will be reduced if the primary input
voltage (AC) is low or the DC voltage is higher
than shown in the chart.
Ambient
Temperature
104° F (40° C)
Duty Cycle 100%
Current 150 Amps
DC Voltage 140 vdc
Power Supply Duty Cycle
6. Pilot Modes
Auto-Restart, Pre-Flow Delay, "Recycle Required"
7. CNC Signals
Enable, Start/Stop, OK-To-Move, Pilot Sensing Relay (PSR),
Full CNC Available with Remote
8. Coolant Pressure
Internal Service-adjustable
130 psi (8.8 bar) at zero flow
120 - 125 psi (8.2 - 8.5 bar) at 0.6 gpm (2.6 lpm)
9. Coolant Flow Rate
0.5 gpm (2.2 lpm) with 150 feet of total torch and torch leads
at 70°F (21°C)
NOTE
The flow rate varies with lead length, torch con-
figuration, ambient temperature, amperage level,
etc.
10. Cooling Capacity
4,000 to 10,000 BTU
NOTE
Maximum value based on “free flow” condition.
11. Coolant Reservoir Capacity
2 gallons
Capable of handling a total of 150 feet of torch lead
length