SARGENT Keypad Exit Devices - Manual (Page 11)

03/31/14
1-800-810-WIRE • www.sargentlock.com • A7373C 11
Copyright © 2014, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
KP Series
Keypad Mortise Lock
Fire-rated doors require a fire stop plate on
the outside of the door (Fig. 4A).
1. Drill (2) 1/8” x 1-1/4” deep holes
in the door if not already present.
Refer to template for fire-stop
prep locations.
2. Attach with flap up and
out using (2) #8 x 1/2”
self-tapping screws for
wood and metal doors.
B. Weather Conduit
(P/N 52-2847)
Install weather conduit on
NON FIRE-RATED exterior
doors only.
1. Carefully insert the weather
conduit into the ribbon cable
hole on the inside of the door
(Fig. 4B).
2. Place the O-ring around the
weather conduit on the out-
side and up against the door
(Fig. 4C).
of 1-1/2”
Diameter
(2) 1/8” Diameter
Holes Required
Fire Stop Plate
Slot
(2) Self Tapping
Screws #8 x 1/2”
for Wood and
Metal Doors
Fig. 4A
A. Fire Stop Plate (P/N 53-0033)
7/8”
1-1/2”
Outside of Door
Fig.4B
Ribbon Cable Hole
Fig.4C
O-Ring
Step #4 – Exterior Door Options
Step #5 – Install Weatherseal Gasket (Exterior Doors)
1. Carefully remove adhesive backing from the gasket (Fig. 5A).
2. Apply gasket to escutcheon:
• Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
• Work around the escutcheon, pressing the sticky side
of the gasket firmly against the escutcheon edge.
• The gasket should be aligned so that all edges
of the escutcheon are covered.
3. Attach escutcheon to the door.
Note: The 43 cylinder may be used with or without a gasket.
Fig. 5A
Fig. 5B
Peel back