SARGENT Profile Series v.G1.5 Mortise Locks - Manual (Page 7)

Profile Series v.G1.5 Mortise Dorm Lock
6.2 – How to Reverse Lock Hand
Right Hand
Shown
Triangular
slot
Locking
guide slot
Rotate
Push in
RED color
locking piece
indicates locked side
End Cap
End
Cap
Motor harness
with 6-pin connector
& lever monitor
switch harness
with two 2-pin
connectors
Latchbolt
Outside of
door
Front
Deadbolt
Dead Latch
Connector
and wires
Latchbolt
If it is necessary to change hand of latch:
1. Insert blade of common screwdriver into triangular slot behind latch
2. Rotate screw driver and push latch out until back of bolt clears lockbody front
3. Rotate latch 180° until the latch drops back into the lockbody
If it is necessary to change hand of locking piece:
1. Turn lockbody to side NOT marked with RED locking piece
2. Insert blade of common screwdriver into locking piece slot
3. Push locking piece toward front of lockbody and rotate
until RED shows
4. RED indicates locked (outside) side
5. Wire harnesses MUST exit thru non-cylinder side
Note: Black plastic wire guide (not shown) must be
located in the inside cylinder hole and the lockbody
wires are fed through it
Right Hand
Shown
Triangular
slot
Locking
guide slot
Rotate
Push in
RED color
locking piece
indicates locked side
End Cap
End
Cap
Connector
Latchbolt
Outside of
door
Front
Deadbolt
Dead latch
Latchbolt
Right Hand
Shown
Triangular
slot
Locking
guide slot
Rotate
Push in
RED color
locking piece
indicates locked side
End Cap
End
Cap
Connector
Latchbolt
Outside of
door
Front
Deadbolt
Dead latch
Latchbolt
Right Hand
Shown
Triangular
slot
Locking
guide slot
Rotate
Push in
RED color
locking piece
indicates locked side
End Cap
End
Cap
Connector
Latchbolt
Outside of
door
Front
Deadbolt
Dead latch
Latchbolt
5
© SARGENT Manufacturing Company 2006, 2007
For installation assistance, contact SARGENT at 800-810-WIRE (9473)