SARGENT Profile Series v.G1.5 Mortise Locks - Manual (Page 11)

01/31/14
1-800-810-WIRE • www.sargentlock.com • A7855C 11
Copyright © 2014, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Profile Series v.G1.5/LK Mortise Lock
1. Slide lever handle onto spindle
until fully seated (Fig. 8A).
2. Insert #8-32 x 1-1/4” screws through inside
escutcheon and thread into outside escutcheon.
3. Straighten escutcheons and tighten securely.
4. Tighten the set screw securely with 1/8” hex
wrench.
Step #8 – Inside Lever Installation
Step #9 – Install and Secure Cylinder
1. Slide cylinder through the spring and rosette/collar
and screw into lock body, rotating the cylinder clockwise (Fig. 9A).
Cylinder should be flush with rosette/collar.
Note: The 43 cylinder may be used when installing
this product with or without a gasket.
Note: SARGENT logo must be horizontal and
on the top of the cylinder (Fig. 9B).
2. Secure the cylinder by tightening cylinder clamp
screw located above the deadbolt using #2
Phillips screwdriver (Fig. 9C).
3. Using the key, test cylinder functions:
• 8278 Function: Key retracts latch
• 8276 Function: Key retracts
latch and projects and
retracts deadbolt
Fig. 9B
Position cylinder so that the
SARGENT logo is right-side up.
Correct Incorrect
Fig. 9C
Outside of Door
Cylinder Clamp Screw
#2 Phillips
Screwdriver
Fig. 9A
Outside of Door
Key
Type 43 Cylinder
Inside of Door
Fig. 8A
Spindle
Set Screw
Inside Lever