Electroguard, Prefix 80 series exit device, 4installation instructions (continued) – SARGENT FM8700 Surface Vertical Rod Exit Device User Manual
Page 11
Chassis
mounting
holes
Wire &
connector
Inside of door
Opening in
chassis for wires
Chassis arm
Rail wire &
connector
Wire holder
Rail
assembly
Push rail
1. Feed wire and connector through chassis as shown and mount chassis
2. Depress chassis arm and slide rail assembly onto chassis,
capturing the wire from the rail assembly in the wire holder
3. Snap the wire connectors together and gather the excess
wire in the top section of the chassis. Wire tie excess in
place
4. Finish installation per instruction sheet A6696 and Section 10
within this manual
Wire
holder
Chassis arm
A. Installing 59-8300/12-59-8300 Series Mortise Lock Exit Device (continued)
4
Installation Instructions (Continued)
11 1-800-810-WIRE • www.sargentlock.com • A7690E
Copyright © 2013, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
04/15/13
Electroguard
®
59- Prefix 80 Series Exit Device