Great Plains 1525P Operator Manual User Manual
Page 43
Advertising
8/14/2006
118-949M
41
Adjustments
Refer to Figure 50
1.
Engage the upper latch. Make sure the ta-
pered line-up pins near drive sprocket en-
gage completely in line-up holes.
Refer to Figure 51
2.
Engage the lower latch.
NOTE: To change from the Finger Pickup
meter to the Precision meter requires the
same steps.
Refer to Figure 52
The meter drive can be disengaged if a meter is
not being used.
1.
Disengage the drive coupler by pulling out
on the pin, twisting it a quarter turn and rest-
ing it in the shallow slot.
NOTE: A meter must always be assembled
on an opener whether it is being driven or
not. Damage will occur if no meter is in
place.
Disengaging drive coupler is not required to
change meters.
22870
22871
21968
21969
Figure 50
Figure 51
Figure 52
Advertising
This manual is related to the following products: