Great Plains 1525P Operator Manual User Manual
Page 81
Advertising
8/14/2006
118-949M
79
Veris Drive Operating Instructions
Refer to Figure 100
8.
Console window now displays the cal-
ibration number you have selected.
Refer to Figure 101
9.
This returns you back to the begin-
ning of Calibration mode as shown.
To re-run the Calibration procedure,
follow the steps outlined above. It is
suggested that you perform the cali-
bration mode at least twice, and addi-
tional replications may be needed if
Target and Actual amounts vary sig-
nificantly.
Figure 100
22732
Figure 101
22733
Advertising
This manual is related to the following products: