Great Plains 1525P Operator Manual - Manual (Page 76)

1525P, 1510HDP
118-949M 8/14/2006
74
Refer to Figure 85
4. Press Function key until the Calibration
window appears as shown.
5. Press up arrow key to enter calibration
mode.
Refer to Figure 86
6. This is the first window that appears in
Calibration mode. Press Function key to
accept, or Up key to change to metric
settings.
Refer to Figure 87
7. Enter drill width here using Up/Down ar-
row keys. Press Function key to ad-
vance to next window.
Figure 85
Figure 86
Figure 87
22717
22718
22719