Great Plains 1525P Operator Manual User Manual
Page 54
1525P, 1510HDP
118-949M
8/14/2006
52
Planting too little (cont’d)
Not enough talc lubricant
Add more talc lubricant, page 20.
Build up of seed treatment in meter.
Clean out seed meter, page 36. Add more
talc lubricant.
Seed flow shut off not 100% open and
pinned.
Check seed flow shut off, page 35.
Plugged sliding seed tube.
Clean out sliding seed tube.
Plugged opener seed tube.
Lift up drill, expose bottom of seed tube
and clean out.
Seed meter wheel damaged.
Replace seed meter wheel.
Obstruction in meter (foreign material or
uncleaned seed).
Clean seed meter.
Thrown or worn drive chains.
Check drive chains.
Worn sprockets and/or chain idlers.
Replace sprockets and/or chain idlers,
page 62.
Wrong wheel for opener
Green wheel for 25 series and black
wheel for 20 series.
Uneven seed spacing
Excessive field speed.
Slow down. Check Seeding Rate Chart for
correct maximum field speed.
Unclean seed.
Use clean seed.
Lack of talc lubricant.
Build up of seed treatment in meter.
Clean out seed meter, page 36. Add more
talc lubricant.
Seed-Lok™ plugging.
Damaged or missing seed flap.
Replace seed flap.
Opener disks not turning.
See “Opener disks not turning freely” in
this Troubleshooting chart.
Plugged opener seed tube.
Lift up drill, expose bottom of seed tube
and clean out.
Worn/rusted sprockets and/or chain idler.
Check and replace any worn/rusted
sprockets or chain idlers.
Seed meter wheel damaged or worn.
Check seed meter wheel and replace.
Seed meter slide worn.
Replace seed meter slide, page 57.
Plugged sliding seed tube.
Clean out sliding seed tube.
Incorrect seed meter wheel for seed size.
Verify seed count on seed bag with seed
meter wheel.
Uneven seed depth
Excessive field speed.
Slow down. Check Seeding Rate Chart for
correct maximum field speed.
Coulter depth adjustment
Check hitch operator’s manual.
Planting conditions too wet.
Wait until drier weather.
Drill frame height incorrect.
Check drill frame height, page 33.
Drill not level front-to-back in field.
Readjust top link to level drill.
Problem
Cause
Solution