Great Plains 1525P Operator Manual User Manual
Page 87
8/14/2006
118-949M
85
Veris Drive Operating Instructions
Crop
Row
Spacing
Type of
Meter
Meter Part
No
Minimum
Rate
Maximum
Rate
Note
Cal #
Wheat SR
10”
V3
403-120D
92
249
11.33
****
Wheat SR
TR 30” W/Splitters
V3
403-120D
92
249
11.33
****
Wheat SR
15”
V3
403-120D
92
249
7.55
****
Wheat SR
Twin Row 30”
V3
403-120D
92
249
7.55
****
Wheat SR
10”
Wheat Wide
403-119D
69
187
8.50
****
Wheat SR
TR 30” W/Splitters
Wheat Wide
403-119D
69
187
8.50
****
Wheat SR
15”
Wheat Wide
403-119D
69
187
5.67
****
Wheat SR
Twin Row 30”
Wheat Wide
403-119D
69
187
5.67
****
Calibration Table-Volumetric (Low Range)
Motor 12T Driver-Mainshaft 36T Driven
**** Field speed may affect actual rate with volumetric meters. Refer to the oper-
atins sectin to perform the Calibration Routine at your average planting speed.
***** Requires use of 817-529C Flow Gate.
For proper operation of the Great Plains Singulator Plus Meter used on the 25 series opener the 12 tooth
drive sprocket is required on the Veris drive on both sides of the drill. To change to the 12 tooth sprocket refer
to page 77.