Great Plains DICKEY-john Auto Section Control - Manual (Page 17)

OPERATOR’S MANUAL
Auto Section Control System
11001-1561B-201207
INTELLIAG PDC SETUP / 15
2. At the Physical Layout screen, select the appropriate implement layout
type by pressing the tractor/implement graphic.
Figure 14
Implement Layout Types
3. Enter in the table each channel’s X and Y coordinates. X and Y
coordinate measurements will vary based on the implement type
selected.
NOTE: When operating with only 1
control channel, the “Y” value
on the Physical Layout screen
should remain at 0 unless the
implement is offset left or right
of center. IMPORTANT: If there are no rows assigned to a control channel, such
as operating in Monitor Only mode, a row column
appears on the Physical Layout screen and rows must
be assigned an offset.
3 POINT HITCH AND TOWED HITCH
NOTE: Use the gray implement table
on screen as a guide to verify
channels are aligned correctly
as X Y coordinates are entered.
Figure 15
Physical Layout Screen - 1 Channel Assignment (3 Point Hitch and Towed Hitch)
3-Point Hitch Towed Hitch Tow-Behind Cart Rigid-Cart Mount
Select
Implement
Type
Enter X Y Coordinates
for each enabled channel
A red button
indicates
GPS signal
is lost.