Great Plains DICKEY-john Auto Section Control - Manual (Page 5)

OPERATOR’S MANUAL
Auto Section Control System
11001-1561B-201207
INTRODUCTION / 3
INTRODUCTION
Auto Section Control is an automated row shutoff system that can be added
to the IntelliAg planter system to automatically shutoff individual planter
sections utilizing a GPS signal as previously planted areas are approached.
A dedicated Auto Section Control terminal displays a field map for easy
identification of external field boundaries, seeded areas, and nonseeded
areas.
Figure 1
Auto Section Control Terminal and IntelliAg Virtual Terminal
AUTO SECTION CONTROL FEATURES
• Real-time viewing of planting operation within the field without
interruption of application rate and seed monitoring information
• Unique GPS latency adjustment for calibration of row shutoff at the
precise time the planter enters a previously seeded area
• Manual override of planter sections in the event of a lost GPS signal or
in special conditions
• Section(s) shutoff and turn on when exiting or entering a headland
• Day and night mode
• Saving field data by customer, farm, field, and task structure for
viewing at a later date
REQUIREMENTS
The Auto Section Control system will only interface and operate with an
IntelliAg Planter Control system and compatible virtual terminal.
The Auto Section Control system requires the following to operate:
• Compatible with IntelliAg A1+ virtual terminal, John Deere GS2 2600
display, or AGCO C2000 virtual terminal
• Auto Section Control terminal
• GPS receiver (5 Hz minimum)
• Tru Count WSMB module
• Tru Count WSMB harness
• Implement lift switch
• Row section control switch box
Auto Section Control
Terminal
IntelliAg
Virtual Terminal