Humboldt 5000 BLU Light Weight Deflectometer - Manual (Page 22)

22
Power Cable, Testing Computer:
Only the power cable supplied by the manufacturer (SA07-
15US12R) should be used. Charge the device only in dry,
indoors locations. The inner pole is the positive (+) pole.
Type: SA07-15US12R (Touch electronic Co., Ltd)
Prim: 100-240V AC, 50-60Hz, 0.5A Class II
Sec: 12V/1.25A
IP20
First plug the power cable into the appropriate ‘12V / max.
1.25A’ socket of the testing computer, located on the top left of
the control panel. Then plug the other end of the cable into the
wall socket.
When disconnecting the cable always take hold of the plug.
Pulling on the cable may result in damage to the wires.
Power Cable, Bluetooth ® Load Plate
(‘TERRATEST 5000 BLU’ ONLY):
Only the power cable supplied by the manufacturer (SYS1308-
1809-W2E) with LEMO-plugs should be used for charging the
Bluetooth® transmitter in the Bluetooth
® sensor dome. Charge the
device only in dry, indoors locations. The inner pole is the positive
(+) pole.
Type: SYS1308-1809-W2E with LEMO-plugs
Prim: 100-240V AC, 47-63Hz, 1A Class II
Sec: 9V/2A
IP20
First plug the power cable into the socket of the Bluetooth
® sensor
dome. Then plug the other end of the cable into the wall socket.
When disconnecting the cable always take hold of the plug.
Pulling on the cable may result in damage to the wires.
The power cable for the Bluetooth ® load plate (‘TERRATEST 5000
BLU’ ONLY) is equipped with a plug with LEMO ‘PUSH-PULL’ lock
and anti-kink protection. To connect the power cable, first open the
hinged lid of the socket on the Bluetooth
® sensor dome of the
Bluetooth ® load plate and insert the plug of the power cable all the
way until it stops. The plug will lock itself automatically inside the
socket; it can only be disconnected by unlocking the plug.
Accordingly, pull only on the plug. Failure to do so may cause
damage to the cable or socket.
Car Charger for Testing Computer:
Only the car charger supplied by the manufacturer (ITC W24)
should be used. Charge the device only in dry, indoors locations
(e.g. inside vehicles). The inner pole is the positive (+) pole.
Type ITC W24
inner pole positive (+)
Fuse F2L32V (fast)
First plug the power cable into the appropriate ‘12V / max.
1.25A’ socket of the testing computer, located on the top left of
the control panel. Then plug the other end of the car charger into
the cigarette lighter socket.