Baumer NE215 - Manual (Page 14)

14
NE215 Programming mode
5 Programming mode
This section describes the procedure for programming the counter.
Programming mode Operating parameters are set in the programming mode, which is
subdivided into four programming segments.
Programming segment 1 In the first programming segment, all the operating parameters
can be accessed and changed. The operating parameters which are
disabled in the operating mode are also displayed here. The first
programming segment consists of 8 lines.
Programming segment 2 In the second programming segment, the individual operating
parameters for access to the operating mode can be disabled and
enabled. In the first programming segment, access is possible to
these disabled operating parameters.
Programming segment 3 In the third programming segment, all the machine-related
functions and values can be programmed.
Programming segment 4 In the fourth programming segment, the interface parameters can
be programmed.
Keying
To access programming The same key assignments apply to the individual programming seg-
ments. Since key functions may vary in the operating and program-
ming modes, however, all the functions are described in full below.
Key
Function in operating and Transfer to the next operating parameters in the operating and
programming modes programming modes. For a fast run-through, hold the key down.
Key
Function in operating and Transfer from programming to operating mode and vice versa.
programming modes
Keys 0 ... 9
Function in operating and Change of values via the numerical keypad.
programming modes
Key
Function in the operating mode Deletes the display. Reset of possible programmed operating
continuous contacts.
Function in the programming mode Deletes the display. Reset of possible programmed operating
continuous contacts. Selection of output signals on continuous
signal (latch).
Key
Function in the operating mode Transfer from any display to a parameter corresponding the selection
in line 35.
Function in the programming mode In conjunction with the key, transfer to programming mode.