Baumer NE215 - Manual (Page 20)

20
NE215
Programming field 4
Line 43 Baud rate
0 * 4800 baud
1
2400 baud
2 1200 baud
3 600 baud
Line 44 Parity
0 * Even parity
1
Odd parity
2 No parity
Line 45 Address
* 0
1-99
Line 46 Stop bits
0 * 1 Stop bit
1
2 Stop bits
● At the conclusion of these programming lines, a broken line will
appear in the display, signifying the competion of the fourth
programming segment.
To leave programming mode Press the key.
● Counter now reverts to the operating mode.
Reprogramming the counter Switch on the instrument and press the key simultaneously.
to the defaults settings ● All the programmed values will now revert to their defaults
settings.
5.1 Operating modes
The operating modes are described below.
Step preset On reaching a preset value, the counter continues to count to the
next preset value. Preset values are always processed in the
sequence: preset value 1, preset value 2. Any values can be chosen.
External or manual resetting can be carried out at any time.
P1- Self-adjusting preset Preset value P1 serves as a preliminary signal and functions as a
self-adjusting preset. The preliminary signal always switches to the
input value before the final signals is given. Any second preset value
can be chosen.
Programming mode