Baumer NE215 - Manual (Page 23)

23
NE215 Technical data
6.1 Dimensions and cutout size
6.2 Default settings
The following parameters are programmed into the counter by the
factory prior to delivery:
Preset value, main counter P1 100
Preset value, main counter P2 1000
Preset value, secondary counter B1 10
Secondary counter multiplier 1
Display Depending on the model with
either 2 or 3 DP
Pulse signal time
main/secondary counters
0.25s
Counting mode 1 (step preset)
Preset change the new preset becomes
active after reset.
Input function, secondary counter External triggering
Counting frequency,
secondary counter
10 kHz
6.3 Error messages
Error messages and : Fault must be rectified by the factory.
: Excessively fast sequences, i.e.
inadequate intervals between presets
at high counting frequency.
● Error messages and can be cleared with the
key .
72
72
105
100
10
1-6
7
67
.7
Sealing screw
Cutout
68 + 0.7 x 68 + 0.7 mm
Packing
75 min.
68 +0,7
68 +0,7
75 min.