Baumer NE215 - Manual (Page 21)

21
NE215 Programming mode
5.2 Counting modes for the main and totalizing counter
Up/down counting with two counting signals, phase-offset by
90 degrees
The counting direction is automatically identified from the leading/
lagging 90
o phase offset.
The internal phase discriminator performs the necessary evaluation.
5.3 Output responses (Output Modes)
Signal output response is determined by the following:
– Programming of the preset value, output time, output logic and
output function;
– external resetting;
– external counting direction control.
The diagrams belows show the output signal responses.
Adding operating mode
Step preset with continuous signal, without automatic reset
Adding operating mode
Step preset with pulse signal, without automatic reset
Adding operating mode
Self-adjusting preset with pulse signal, without automatic reset
Input of the preset value P1 corresponds to the interval between the
preliminary signal and the final signal. This means that, if the final
signal (i.e. preset value P2) is changed, the preliminary signal is
automatically readjusted.
Track A
Track B
RESET
VW (P2)
VW (P1)
O (SC)
OUT P1
OUT P2
RESET
SC
VW (P1)
VW (P2)
OUT P1
OUT P2
RESET
VW (P2)
O
OUT 1
OUT 2
(SC)
VW (P1)
Tw
Tw