Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 152)

A-16 Installation and Troubleshooting Guide
DIAG-CMINOCAP
(T!--
[cmiTest]
CMI intended receiver ASIC
failed to get CMI capture flag ASIC or mainboard
failure Replace main-
board assembly
DIAG-CMISA1
(T!-!
[cmiTest]
An attempt to send a CMI mes-
sage from ASIC to ASIC failed ASIC failure Replace main-
board assembly
DIAG-CMNOBUF
(T!
[centralMemoryTest]
Port could not get any buffer ASIC failure Replace main-
board assembly
DIAG-DATA
(T! (5- (
[portLoopbackTest, crossPort-
Test]
Payload received by port did
not match payload transmitted Mainboard, GBIC
module or fiber
cable failure Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-ERRSTAT
(T! ! 75- 
- 75
- - 7
[portLoopbackTest,
crossPortTest, spinSilk]
Port Error Statistics counter is
nonzero, meaning an error was
detected when receiving
frames.
One of the following status
errors occurred:

Enc_In: Encoding error,
inside frame

CRC_err: Cyclic redun-
dancy check on frame
failed

TruncFrm: Truncated
frame

FrmTooLong: Frame too
long

BadEOF: Bad end of file.

Enc_out: Encoding error,
outside frame

BadOrdSet: Bad symbol
on fiber-optic cable

DiscC3: Discarded Class 3
frames
ASIC, mainboard,
GBIC module or
fiber cable failure Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-INIT
(T! )5- )5- )
[portLoopbackTest, crossPort-
Test, spinSilk]
Port failed to go active in the
loopback mode requested ASIC, mainboard,
GBIC module or
fiber cable failure Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-INTNIL
(T!-
[cmlTest]
ASIC failed to get a CMI error
(interrupt) ASIC failure Replace main-
board assembly
0 2
  + &

     & 
  )