Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 47)

support.dell.com Managing the PowerVault 56F 16-Port Fibre Channel Switch 3-13

 


Pressing <Enter> while Frame Collection is selected displays a frame collection
method.
This command specifies two frame collection methods, bundle and piling. Using bun-
dling, frames are separated in different queues based on source/destination pairs.
Using piling, frames are accumulated per destination AL_PA if NL_Ports can handle
multiple frames in a loop. Additionally, piling can minimize loop traffic by reducing
overhead and increases the loop efficiency.
To set, press <Tab> for Bundle or <Enter> for Piling.
%


#
+ 
Pressing <Enter> while Reset to Default is selected displays a Yes or No.
Clicking Yes and then pressing <Enter> causes all values in the Configuration Menu to
reset to default conditions. Once the Ethernet IP address and the switchname are
changed, they are not reset to default values.
NOTE: Resetting the switch to default causes all configuration settings, names, and
passwords entered to be reset to default settings.


# 
Pressing <Enter> while the Port Disable message is selected displays a submenu to
select the port to disable.
Pressing <Enter> while a selected port is displayed disables the port. The LED associ-
ated with the port changes from green to amber indicating the selected port has been
disabled.


 
Pressing <Enter> while the Port Enable message is displayed opens a submenu
where you select the port.
Pressing <Enter> while the selected port is displayed disables the port. The LED
associated with the port changes from green to amber indicating the selected port
has been enabled. When FL_Ports are enabled, the port initializes the loop attempting
to be the master.

&



Pressing <Enter> while the Close Telnet Session message is displayed causes the
Telnet session to close immediately.
%

Pressing <Enter> while the Reboot message is displayed causes the switch to
reboot immediately.