Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 96)

4-40 Installation and Troubleshooting Guide

4%
The following example shows the routeHelp command screen, which displays the
routing help commands.
%


#
The topologyShow command displays all paths to a domain including:

Output port(s) used to route frames to the domain

The routing cost to reach the domain

The input ports routed through the output port
The FSPF protocol supports equal cost multipaths, so there could be multiple parallel
paths between two switches.
The command syntax is topologyShow to list all domains.
The command syntax is topologyShow <domain ID> to list the specified
domain.
State The neighbor’s current state; its value must be NB_ST_FULL
for the ISL to forward frames to the adjacent switch; other
values may be transitory, however if a value is retained for
more than ten seconds, contact Dell for technical assistance
( (

 !!'
'   

%    
 6 48'
D


 #6 94 
4
4


#6 94)#9)  4
4
4


#6 94)#9)4


4
4
 /

 $'4

6
4


4
 #
 $'446
4


4
2#3#6 9424?#
3

4
 #6 94'  
4
4
4#
#6 944
6C'4
4
 #6 946 4,.
'/'
"4
 "4
'
 '4 '
'/'
/

/

 '4 '

'/'
#6 94C'4 '44