Dell PowerVault 56F (16P Fibre Channel Switch) - Manual (Page 59)

support.dell.com PowerVault 56F 16-Port Fibre Channel Switch Commands 4-3
# 9 '44 

4 4
'4
"'4#

"
,.


4 4
'


"'4!%(>'
,.


4 4
'


"'4-
,.


4 4
'


"'4 '  ,.


4 4
'


"'4 4,.


4 4
'


"'4 )
"644
,.


4 4
'


 48
Table 4-2 describes the fields for the agtcfgDefault command.
(
% % !!'
'   
%    
sysDescr The system description (in MIB-II definition). The default
value is set as Fibre Channel Switch.
sysLocation The location of the system (switch) (in MIB-II). The default
value is set as End User Premise.
sysContact The contact information for this system (switch). The default
value is set as Field Support.
swEventTra-
pLevel The event trap level in conjunction with an event's severity
level. When an event occurs and if its severity level is at or
below the set value, the SNMP trap, swEventTrap, is sent
to configured trap recipients. By default, this value is set at
0, implying that no swEventTrap is sent.
Other possible values are:
0 = None
1 = Critical
2 = Error
3 = Warning
4 = Informational
5 = Debug
See “errShow” found later in this chapter for related
information.