Nikon 35MM Film Scanner LS-10E User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 3.6 Computer power supply connector
Connecteurs d’alimentation d’unité centrales
Stromversorgungsstecker des Computers
38
Step 4 Feed the computer power connector
Feed the computer power 4-pin connector, as shown in
Figure 3.6, through the drive bay from the inside as far
as it will extend out through the drive bay. Connect the
cords with each 12 V DC or 5 V DC connector.
[a] Computer power connector (Typical connector
on four wire cable)
[b] Y-Adapter power connector (Optional Y-type
power connector)
Step 5 Slide the LS-10 part way into the
drive bay
Thread the unconnected end of the 50-pln SCSI cable
through the drive bay and pull it through into the inside
of the computer while sliding the scanner rear-first into
the drive bay. The scanner should slide in easily if the
rails are properly positioned. Push the scanner in so
that the rear of the scanner aligns with the computer
power connector.
Warning!
The top or bottom of the scanner should not touch
anything whfsn sliding,Into 'the computer. Damage
''cai^ occur to the scanner or to other devices If the
scanner scrapes during installation.
Step 6 Connect the power connector
Connect the 4-pin power connector of the computer to
the 4-pin power connector of the scanner. Note that both
connectors are keyed so that one side of the connector
is beveled. Be careful to insure that the beveled edges
are properly aligned. Under certain circumstances, it is
possible to force the connector in at an improper angle
thereby creating a backward connection. Extreme
damage can occur to the scanner should this happen.
Make sure that the connection is correct.
Note: An optional Y-adapter may be necessary if there
are not any available power connectors in the
computer.
Vi(arningl
' Never attempt to connect power to'the scanner with
the computer power on."