Nikon 35MM Film Scanner LS-10E - Manual (Page 42)

Determining which ID to use
If the scanner is the only SCSI device that will sit on the
SCSI bus, there is no need to change the SCSI ID from
the preset value.
If the scanner must share the SCSI bus with one or
more other peripherals, it is necessary to insure that no
two peripherals have the same ID. Create a list of SCSI
peripherals (see Table 3.2) on the desired bus, noting
the device type and the SCSI ID of that device. To
determine the SCSI ID of the other peripherals, check
the rear of each peripheral for some indication of the
SCSI ID of that device. If there is no indication as to the
ID number, then consult with the peripheral’s user's
manual or call the peripheral manufacturer to determine
the SCSI ID setting.
SCSI ID Device Type
0 Computer (default)
1
2
3
4
5 LS-10 Scanner (default)
6
7
Table 3.2 Typical SCSI ID chart
Warning! , ^
Neyer'ichange the SCSI ID of,at device“with the ■
___ _ t U. . I. ‘
¿(^mputdrlruhning
If another SCSI peripheral shares the same SCSI ID as
the LS-10, change the SCSI ID of the LS-10 to an unused
SCSI ID as indicated in the following sections. Note any
changes in Table 3.2.
42