AVer MXR6008 - Manual (Page 102)

96
- Start Recording
Record the video from the selected camera.
1. Beside the Start Recording check box, click
Detail.
2. In the Alarm Recording Setting dialog box,
select the camera to enable/disable video
recording. Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting
to record the number of frames based on the
Recording Setting.
4. In the Start Record prior text box, mark and
set the number in second for the program to
begin recording after the alarm has been trigger.
The time range is 1~10 seconds.
5. In the Stop Record after text box, mark and set the number in second for the program
to continue recording after the alarm has ended. The time range is 1~999 seconds. If
user doesn
’t mark and set the time, the alarm recording will continue recording until
alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point
setting. Beside the PTZ preset point check box,
click Detail. In the Trigger PTZ Preset Setting
dialog box, select the PTZ camera number then
select the Enable check box. Select the position of
the PTZ camera when the alarm is activated and
ended. For the PTZ camera end point, user can
also select on preset position or Auto Pan between
preset position groups.
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video
to CMS when the alarm is activated.
Beside the Send to CMS check box, click Detail. In
the CMS Setting, select the camera to
enable/disable sending the video to CMS. Enable
All to select all cameras. Then, click OK to accept
the new settings and Cancel to exit without saving.