AVer MXR6008 - Manual (Page 65)

59
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend
additional time in second before it stops the relay operation.
1. Beside the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list and in the ON column,
set to enable/disable the relay operation when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable to extend the relay operation
time and set the duration in second.
4. Click OK to exit and accept the setting and Cancel to exit without saving the setting.
- IP Camera Relay
Set to enable/disable the relay operation when the alarm is activated. In Status column, click to
change the relay device status
– circle means the status is on and blank means is off status.