AVer MXR6008 - Manual (Page 140)

134
 Reboot: when the DVR system reboot without abnormal condition, the system will
send out the alarm message.
 Abnormal Reboot: when the DVR system reboot in irregular condition, the system
will send out the alarm message.
 Recording is switched off: when the recording has been stopped, the system will
send out the alarm message.
 Hard Disk failed: when the hard disk doesn ’t work normally, the system will send out
the alarm message.
7. In Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is
reset, all alarm action will stop at the moment. If the sensor normal status is high, set the
alarm reset condition to low. To set sensor status of IP camera, click IP Camera Sensor. In IP
Camera Alarm Setting window, click High/Low to set sensor status.
8. In Action, you may now set the alarm action for the system to perform when the alarm
condition is activated.