Preparing the machine before installing the hoop, Attaching and removing embroidery hoop – SINGER SES1000 FUTURA User Manual

Page 70

Advertising
background image

0

PREPARING THE MACHINE BEFORE
INSTALLING THE HOOP

1. Turn hand wheel toward you until needle comes to its

highest position.

1

ATTACHING AND REMOVING
EMBROIDERY HOOP

1. Raise presser foot and needle, and push up lever (A) of

embroidery foot with your finger and pass embroidery hoop
under it.

 To remove, pull the hoop forward to slide it out from

underneath the embroidery foot.

2. Attach hoop to embroidery unit by aligning hoop mounting

screws (D) and the grooves in hoop mounting plate, fitting

projections (C) on hoop bracket into square holes (B) in
hoop mounting plate. Securely tighten hoop mounting
screws (D) with screwdriver.

 To remove, loosen hoop mounting screws (D) and remove

the hoop from the hoop bracket.

NOTE: Before attaching small hoop, turn on power switch to

move the carriage to embroidering standby position.

( A )

2

1

( B )

( B )

(D)

(C)

(D)

Hoop mounting plate
Plaque de montage de cerceau
Placa de montaje de aro

Carriage
Chariot
Carro

Advertising
This manual is related to the following products: